honefr wrote:A když už jsme tady v tom nemohl by mi někdo polopatě napsat jaký je rozdíl mezi těma režimama
Já vím je to tam napsané ale nějak se tou angličtinou nemůžu prokousat

| Normal: Simply enable the flashlight until the application is started again or
| the configurable timeout occurs (60 seconds by default). This mode
| can be used for a prolonged period. I have only tested it up to 5 minutes
| though.
Standardní režim - zapne diodu. Vypnutí provedeš opětovným spuštěním programu nebo k němu dojde automaticky po přednastavené době (výchozí 60 sekund). Možno použít pro delší přisvícení. Testováno 5 min.
| Bright: The Bright mode is exactly the same as the Normal mode, with the only
| difference being that the LED is more bright. This mode is equal to the
| short moment when you make a photo with flashlight on. Note that this mode
| does stress the LED and should not be used for prolonged periods. On the
| Touch Pro I have used this up to a minute without problems. This feature
| may or may not be available on some devices.
Totéž co předtím, dioda však svíti jasněji. Intenzita odpovídá blesknutí při pořizování fotky. Nemělo by být používáno delší dobu. Testováno 1 min bez potíží.
|
| Blink: The Blink mode turns the LED on and off in specific intervals that you
| can configure in the registry. An example of usage is the bike light.
Režim blikání. Zapíná / vypíná diodu v intervalu nastaveném v registrech systému. Použití např. jako světlo na kole.
|
| SOS: This is extensive mode that supports sending custom morse code. The text
| to be sent via morse code signals can be configured in the registry. This
| defaults to "sos ", thus the SOS name for this mode. NOTE that the flashlight
| timeout does NOT interrupt a text. It checks if the timeout occurred when it
| starts over again and quits when it reached the timeout.
Vysílá kód SOS v Morseově abecedě.
| PTT: The Push-To-Talk/Torch mode. When you device has a key you can map to 'hold',
| you can use this feature to keep the light on as long as the key is pressed.
| The AT&T Fuze is one of those devices with a PTT button.
Pro zařízení s HW klávesami. Po namapování aplikace na stisk klávesy se rozvídí dioda. Svítí po celou dobu, kdy bude HW tlačítko stisknuté.